3D printer manufacturer Bambu Lab’s newest firmware update for its A- and P-Series 3D printers has ignited backlash within the 3D printing community, with critics accusing the company of reinforcing i
Disclosure: I do not have one. I have a creality k1 and it’s mostly great for me, but it isn’t perfect and I personally would buy a prusa if I was buying a new printer.
They’re not comparable printers though, you should be comparing the Prusa core one to the Bambu P1-series. The Bambu P1-series is still less than half of the prusa core one of course.
It’s not just smaller, it also has limitations in materials it can print because it’s not an enclosed printer. The core one can print ABS/ASA much more reliably, PC, Nylon and other fancy stuff the A1 just can’t. Their motion systems are also completely different as the core one uses coreXY and the A1 is coreXZ (aka. bedslinger).
A decent bedslinger is easy to come by these days, if that’s all you need there are many others to go with, e.g. Sovol which is using open source klipper.
nope, and this is why I have a P1S and not one of the alternatives (and the one time I did need to tinker, because my AMS’ internal hub unit failed and needed replacing, Bambu CS handled it well and fairly quickly)
Any good alternatives to Bambulab printers? Don’t want a printer that I habe to tinker with, want one that just works😅
Elegoo Centauri Carbon, Artillery M1 Pro, Qidi Plus4, Prusa Core One
Prusa Core One. Can buy it prebuilt or as a kit.
Disclosure: I do not have one. I have a creality k1 and it’s mostly great for me, but it isn’t perfect and I personally would buy a prusa if I was buying a new printer.
But is a 1000€ printer an alternative for a 200€ Bambu A1?
They’re not comparable printers though, you should be comparing the Prusa core one to the Bambu P1-series. The Bambu P1-series is still less than half of the prusa core one of course.
I get your take, the A1 Mini is smaller, but in the end, it’s a printer with crazy good value.
I guess I will also buy a Prusa next time. My P1S has internet blocked in my firewall, and I’ll use it in LAN mode until it dies.
It’s not just smaller, it also has limitations in materials it can print because it’s not an enclosed printer. The core one can print ABS/ASA much more reliably, PC, Nylon and other fancy stuff the A1 just can’t. Their motion systems are also completely different as the core one uses coreXY and the A1 is coreXZ (aka. bedslinger).
A decent bedslinger is easy to come by these days, if that’s all you need there are many others to go with, e.g. Sovol which is using open source klipper.
absolutely, see other comments
nope, and this is why I have a P1S and not one of the alternatives (and the one time I did need to tinker, because my AMS’ internal hub unit failed and needed replacing, Bambu CS handled it well and fairly quickly)